* fix(volume): keep vacuum running past dangling .idx entries
Vacuum compaction aborted entirely on the first .idx entry whose offset
pointed past the end of the .dat file, surfacing as `cannot hydrate
needle from file: EOF` and stalling progress on every other volume.
In both Go and Rust:
- During compaction, skip an unreadable needle and continue. The bytes
it pointed at were already unreachable via reads, so dropping the
index reference makes the post-vacuum volume consistent. Real EIO
still bails out so a disk fault is not silently papered over.
- At volume load, do a single linear scan of the .idx and confirm
every (offset + actual size) fits inside .dat. The pre-existing
integrity check only looked at the last 10 entries, so deeper
corruption (e.g. left over from a crashed batched write) went
undetected and only surfaced later as a vacuum EOF. A failure now
marks the volume read-only at load time so an operator can react.
Refs #8928
* fix(volume): only skip permanent-corruption needle reads during vacuum
Address PR review feedback (gemini-code-assist + coderabbit):
The original patch skipped any non-EIO read failure, which would silently
drop needles on transient errors — Windows hardware bad-sector errors
(ERROR_CRC etc.) never surface as syscall.EIO; tiered-storage network
timeouts and EROFS would also slip through and shrink the volume.
Switch to an explicit whitelist of permanent-corruption shapes:
- Add needle.ErrorCorrupted sentinel and wrap CRC and "index out of
range" errors with %w so callers can match via errors.Is.
- copyDataBasedOnIndexFile now skips only when the read failure is
io.EOF, io.ErrUnexpectedEOF, ErrorSizeMismatch, ErrorSizeInvalid,
or ErrorCorrupted. Anything else (real disk faults, environmental
errors, Windows hardware codes) aborts the compaction so an
operator notices.
- Mirror the same whitelist in the Rust volume server, matching on
io::ErrorKind::UnexpectedEof and the NeedleError corruption variants
(SizeMismatch, CrcMismatch, IndexOutOfRange, TailTooShort).
Also add `defer v.Close()` in TestVerifyIndexFitsInDat so Windows
t.TempDir() cleanup can release the .dat/.idx handles.
Refs #8928
* fix(volume): wrap entry-not-found size-mismatch with ErrorSizeMismatch
Address PR review: the fallback branch in ReadBytes returned an
unwrapped fmt.Errorf, so isSkippableNeedleReadError (and any caller
using errors.Is(..., ErrorSizeMismatch)) could not match it. Wrap
with %w so the whitelist applies, while leaving the existing direct
sentinel return for the OffsetSize==4 / offset<MaxPossibleVolumeSize
retry path unchanged so ReadData's `err == ErrorSizeMismatch` retry
still triggers.
Refs #8928
* fix(volume): integrate dangling-idx check into existing index load walk
Address PR review (gemini-code-assist, medium): the structural .idx
check used to do a second linear scan of the index file at every volume
load, doubling the disk-I/O cost on servers managing many volumes.
Track the largest (offset + actual size) seen during the existing
needle-map load walks (`LoadCompactNeedleMap`, `NewLevelDbNeedleMap`,
`NewSortedFileNeedleMap`'s `newNeedleMapMetricFromIndexFile`,
`DoOffsetLoading`) on a new `MaximumNeedleEnd` field on `mapMetric`,
exposed as `MaxNeedleEnd()` on the NeedleMapper interface.
`volume.load()` then compares `nm.MaxNeedleEnd()` to the .dat size
after the load is complete — pure numeric comparison, no extra I/O.
The standalone `verifyIndexFitsInDat` helper and its caller in
`CheckVolumeDataIntegrity` are removed; the test that used to drive
the helper directly now exercises the new path via
`LoadCompactNeedleMap`.
Mirror the same change in the Rust volume server: track
`max_needle_end` on `NeedleMapMetric`, expose via `max_needle_end()`
on `CompactNeedleMap`, `RedbNeedleMap`, and the `NeedleMap` enum.
The Rust load walk already happens in `load_from_idx` for both map
kinds, so the structural check becomes free.
Refs #8928
* optimiz vacuuming volume
* fix bugx
* rename parameters
* fix conflict
* change copyDataBasedOnIndexFile to an instance method
* close needlemap
* optimiz commiting Vacuum volume for leveldb index
* fix bugs
* fix leveldb loading bugs
* refactor
* fix leveldb loading bug
* add leveldb recovery
* add test case for levelDB
* modify test case to cover all the new branches
* use one tmpNm instead of two instances
* refactor
* refactor
* move setWatermark to the end
* add test for watermark and updating leveldb
* fix error logic
* refactor, add test
* check nil before close needlemapeer
add test case
fix metric bug
* add tests, fix bugs
* adjust log level
remove wrong test case
refactor
* avoid duplicate updating metric for leveldb index
Chris Lu