What the charger is set to, where the setting is made

The nine values the charger reports back about itself — the current limit, the
timeout, the phase setting, whether boost took, the last command it accepted,
the charging mode, the two balancing flags, the LED — sat fourth in the readings
card, under a phase table and a live-data block. They are the readback of what
the control card's buttons just wrote, so they were being read straight after
pressing something, at the bottom of the longest card on the page.

They get their own card, directly under control in the default order, and the
readings card keeps what it is for: what the charger is doing right now, what it
is, and any alarm. Nothing is shown twice.

The card folds and drags by its heading like the other four, on the same
chargerCardOrder. A column somebody has already arranged doesn't mention this
key, so there it arrives at the end rather than in the middle of a layout that
was chosen — the rule a tab added in a later release already follows — and one
drag settles it.

It appears on the Modbus path only, because that is the only transport that
reports a settings snapshot at all; the OCPP one has nothing to put in it.

Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>

Web App/web/src/i18n/da.json

@@ -116,6 +116,7 @@
       "phases": "Pr. fase",
       "live": "Live data",
       "settings": "Indstillinger",
+      "settingsTitle": "Laderindstillinger",
       "device": "Enhed",
       "alarms": "Alarmer",
       "phase": "Fase",